Liquitreat

LIQUITREAT
Complete Liquid Boiler Water Conditioner
for Boilers up to 30 Bar Pressure

Product Description
LIQUITREAT is a liquid blend of alkaline mineral salts, sequestering agents, scale
and corrosion inhibitors, oxygen scavenger and sludge conditioner.

Directions for Use
The main attributes of LIQUITREAT are:-
* Correct precipitation of hardness salts in conjunction with phosphate
* Neutralisation of acid conditions
* Avoidance of caustic corrosion
* Control of magnesium and calcium salts
The alkalinity “balance” is extremely important for efficient water treatment.
LIQUITREAT provides this whilst avoiding excessive pH levels which could cause
embrittlement and corrosion of boiler components.
Hardness Control: LIQUITREAT provides a phosphate reserve to effectively react
with and precipitate the hardness salts introduced with the feed water. The
formation of insulating scale on hot metal surfaces is prevented as the salts produced
will not adhere and so optimum heat transfer efficiency is maintained. The stable
phosphate compounds used in LIQUITREAT will maintain their efficiency
throughout the boilers normal operating temperature range. Where low
temperatures can cause low phosphate levels, this is avoided.
Sludge Conditioning: Boiler sludge can most easily be removed by blow down if it is
free flowing. LIQUITREAT will ensure this by preventing the scale from coalescing
to form large crystals or adhering to metal surfaces. The resulting sludge is free
flowing & will easily be removed by blow down when required.
Oxygen Control: Oxygen scavenging becomes more vital with an increase in boiler
pressure. The oxygen scavenger will effectively react with dissolved oxygen even at
lower temperatures.

Dosing Methods:
LIQUITREAT is best fed into the boiler feed line by means of a metering pump.
Gravity fed systems should be dosed by means of a flowmeter and dosing drum. DO
NOT SLUG DOSE.
Initial Dose: Untreated System 5 litres / 1000 litres distilled feed water
resulting in 100ppm P. Alkalinity.
Additional dosing of LIQUITREAT is required to bring the P-Alkalinity level to a
mid point of 200ppm. Blow down is dependant on Alkalinity & Chloride levels. If
alkalinity drops below 100ppm, increase the dosage by 20%, if alkalinity exceeds
200ppm, reduce dose by 20%.
In general the ranges are:- 100-300ppm P Alkalinity. 200ppm Chloride maximum.

Physical Properties:
Appearance: Clear liquid
Specific Gravity: 1.17
Odour: Faint
Boiling Point: Approx. 105'C
Stability: Infinite
pH: 14Features & Benefits
* Complete “one shot” liquid
conditioning treatment
* Boiler kept at peak level
efficiency
* Heating surfaces kept clean
and so optimum conditions
exist
* Promotes protective films to
prevent boiler steel
corrosion.
* Dispersant action suspends .
sludge and sediment
particles for efficient
blowdown.
* Reduced Maintenance
* Oxygen scavenging for
increased protection.
Applications
Suitable for use with :-
Auxiliary Boilers
Waste Heat Boilers
Economisers
Package Boilers
Smoke & Water Tube Boilers
Steam/Steam Generators
- up to 30 bar pressure.